Digital-alert-systems DASDEC-II QUICK START UP GUIDE Manual de usuario descargar pdf (Pagina 8)

Quick Start Guide for Your DASDEC II Page 8 of 40

12) The IP Address is now set. All further programming will be accessed through the DASDEC-

II’s embedded website by typing its assigned IP Address into an Internet browser on a

computer on the same network.

Step 2 – Connecting the Audio Wiring

DASDEC™ EAS Monitoring Inputs

Quick Wiring / Configuration Guide

Overview

1. ALL units have the F-connectors, but NOT all units have the internal radios.

 Externally - If the unit shipped with caps over the antenna inputs then it does not contain radios.



Internally - under Setup > Audio units with internal radios will have a “Radio Tuners” tab available

2. Wiring of the 1/8” mini stereo input audio connectors is shown in Figure 1.

 Tip is Left input

 Ring is Right input

 Sleeve is common ground

Figure 1: Wiring diagram for 1/8 mini stereo plugs

3. All monitoring inputs are mono only

4. Inputs use “blue” 1/8 mini plug inputs on the rear panel

5. Units with the EXP-EAS expanded audio inputs have an additional Auxiliary 2 input board for two (2)

additional inputs and expanded selections under the Setup > Audio > Decoder Audio tab. Following

similar settings for Auxiliary 1 noting this provides line in only connections.

6. DASLC and DASLCR models do not have Auxiliary Inputs

Section continues on next page

MainAudio–R1

AuxiliaryAudio–R2

MainAudio–L1

AuxiliaryAudio–L2

CommonGround

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Sin comentarios

Digital-alert-systems DASDEC-II QUICK START UP GUIDE Manual de usuario Pagina 8